|
Purpose:
To change a closed polyline starting point selecting a vertex as the new polyline starting point.
Command sequence:
Command: CST_CHPOLSP
Select polyline: [Select any polyline in drawing]
Select new start point: [Select a polyline vertex point]
***Polyline start point was changed.
Comments:
· You can use this command to change the point where the description begins before you insert a metes & bounds table.
· This command can be used only in closed polylines. You can use the AutoCAD PEDIT command, option CLOSE to close an existing polyline.
· A polyline is also considered closed if the last vertex is in the same position as the start vertex.
|